Line 28: Line 28:
# Depressurize
# Depressurize
# Remove fuel line (cover in
# Remove fuel line (cover in
=== Initial Lift ===
# Support transmissision w/ jack and block of wood
# Lift Engine Slightly
# Remove last 2 bellhousing bolts
# Remove Engine Mount Brackets
# Disconnect fuel line (do it last so you don't smell fuel)

Revision as of 08:10, 6 May 2021

Tips for Pulling Engine

Prep

  1. Spray Rust Pentrant
    1. Exhaust Manifold
    2. Engine Mounts
  2. Drain Coolant
  3. Drain Oil
  4. Mark Plug Wires

Underneath

  1. Disconnect Exhaust Manifold
  2. Mark Bolt on Torque Converter w/ White Paint

Front

  1. Alternator
  2. Power Steering
  3. Compressor
  4. Intake (Upper and Lower)
  5. Fan, Radiator, Condensor

Engine Mount

  1. Remove Engine Mount to Frame Nuts
  2. Loosen Engine Mount to Engine Bolts
  3. Once Engine is on Hoist slightly, remove engine mount entirely to make it easier to dismount/mount transmission

Fuel

  1. Depressurize
  2. Remove fuel line (cover in

Initial Lift

  1. Support transmissision w/ jack and block of wood
  2. Lift Engine Slightly
  3. Remove last 2 bellhousing bolts
  4. Remove Engine Mount Brackets
  5. Disconnect fuel line (do it last so you don't smell fuel)