A300 Startup Checklist

EFB

• Ground Ops > Ground Services
  • External Power
  • Chocks
  • Airstairs
  • Loader
  • Fuel Truck
• Load Manager
  • Consult Flight Plan for Block Fuel (lbs) and Add Fuel
  • Load Cargo

Overhead

1. Elec Pwr (middle left)
   1. Battery 1, 2, and 3
   2. Ext Power
   3. Galley (bottom)
2. Top
   1. NAV 1, 2, 3
   2. Cockpit Door
3. FLT RCDR: GND CTL
4. EXT LT
   1. Beacon ON
   2. NAV 2
5. Bottom
   1. Pitch Trim 1/2
   2. Yaw Damper 1/2
   3. ATS
6. Fuel
   1. All Fuel Pumps
7. Main Deck Cargo Smoke Det
   1. Main, MD1, AFT, Cargo
   2. Probe HEAT ON
   3. Window Heater ON
8. Bottom Right
   1. Emergency Light
   2. Passenger Seatbelt
   3. Non smoking

FMS

1. Numpad 5 to select correct view
2. CLR
3. Dept/Arriving Airports (ie. KMEM/KATL)
4. INSERT (top right)
5. RETURN
6. ALIGN IRS (CLR to cancel)
7. Enter Cost Index (taken from flight plan)
8. Cruise Altitude (taken from flight plan)
9. Flight ID (FDX1313)
10. Align IRS
11. CRZ/WIND (taken from flight plan) (287/09)
12. NEXT PAGE: INIT (taken from EFB Load Sheet or flight plan)
    1. BLOCK (31.8)
    2. ZFW (246.5)
    3. CG (30.1)

EFB

1. Load Payload/Fuel
2. Send to T.O. PERF

FMS

1. F-PLN

EFB

• Ground Ops > Dismiss
  • Air Stairs
  • Fuel Truck
  • Loader

APU (Upper middle)

• APU Button ON
• Start
• Wait until AVAIL
• APU Bleed On (right)
• EXT PWR OFF
• Verify PARKING BRAKE
• From EFB: Remove EXT PWR, Chocks
• From EFB: Push Back

• Get Axxx Altimiter reading from Flight Plan and set Altimiter

Starting Engines

1. ENG START
   1. Mode Selector B
   2. Start 1 ARM
   3. Wait for N2 to reach around 22%
   4. Start Engine 1
   5. Start 2 ARM
   6. Set Parking Brake
   7. Wait for N2 to reach 22%
   8. Start Engine 2